Inside metal gear micro servo BLUE BIRD BMS-375DMG 2.3 kg-cm HV 25T
This servo is suitable for Traxxas Summit for locking differentials and switching speeds.
But it must be sealed.
Dimensions: 24.5 x 11.5 x 23 mm / 0.99 x 0.46 x 0.91 inch
Torque At 4.8V: 1.6kg/cm , 22 oz/in
Torque At 6.0V: 2.3kg/cm , 28 oz/in
Speed At 4.8V: 0.13sec / 60 deg at no load
Speed At 6.0V: 0.11sec / 60 deg at no load
1. M9.6 ball bearing (si-oil)
2. High-torque motor with low RF noise (CE certified)
3. Rubber seals for waterproof case - I have not found
4. Designed for 3D airplane and helicopter, 1/18 car, and glider applications.
5. Futaba compatible 25 tooth output splines
6. Digital motor drive with ultra-square PWM signal
7. Automatic determination of servo center pulse width
8. Metal gears of aluminum 6061 material combined with light and strong C95 material
9. Fail-Safe function
10. 2PEW coated motor wire for high-temperature use
11. Digital control IC - SOP package with 12bit data transfer
12. MOS-FET motor driver chips that can handle 7A peak loads
13. Useable on 6.0V
No comments:
Post a Comment